Differences

This shows you the differences between two versions of the page.

--- howto:linux:install:fedora [2013/07/15 09:52]
zip [1.Download Serviio]
+++ howto:linux:install:fedora [2015/01/19 14:51] (current)
zip
@@ Line 4: / Line 4: @@
   * Update your system <code>yum update</code>
   * Make sure you install rmpfusion packages free and non-free from: http://rpmfusion.org/Configuration/ Just click on Fedora x (your release) and install via Software manager.
-  * Next up, check your java is installed by running <code>yum install java-1.7.0-openjdk</code> (newest release at time of writing this page)
+  * Next up, check your java is installed by running <code>yum install java-1.7.0-openjdk</code> (newest release at time of writing this page) FIXME Java 8 required now
   * Then install ffmpeg with <code>yum install ffmpeg</code>
+**For ffmpeg on Fedora 20**
+<code> rpm -Uvh http://rpm.livna.org/livna-release.rpm</code>
+<code>yum install gstreamer-plugins-bad gstreamer-plugins-bad-free-extras gstreamer-plugins-bad-nonfree gstreamer-plugins-ugly gstreamer-ffmpeg ffmpeg mencoder ffmpeg2theora mplayer libdvdcss</code>
 ==== 1.Download Serviio ====
 <code>wget http://download.serviio.org/releases/serviio-1.2.1-linux.tar.gz</code>
 ==== 2.Extract Serviio ====
-<code>tar -C /opt -zxvf serviio-1.1-linux.tar.gz
+<code>tar -C /opt -zxvf serviio-1.2.1-linux.tar.gz
-mv /opt/serviio-1.1 /opt/serviio</code>
+mv /opt/serviio-1.2.1 /opt/serviio</code>
 ==== 3.Create Serviio's user ====
 <code>useradd -d /opt/serviio -r serviio
@@ Line 17: / Line 20: @@
 ==== 4a.Fedora >= 15 - Systemd script ====
 Create the systemd script /lib/systemd/system/serviio.service with the following code: (If content library is available via nfs or cifs, add remote-fs.target in After=)
-<code>[Unit]
+<code>
+[Unit]
 Description=Start the serviio DLNA server in headless mode
 After=local-fs.target network.target
@@ Line 23: / Line 27: @@
 [Service]
 Type=simple
-User=serviio
+User=root
 ExecStart=/opt/serviio/bin/serviio.sh
 ExecStop=/opt/serviio/bin/serviio.sh -stop
@@ Line 29: / Line 33: @@
 [Install]
-WantedBy=multi-user.target</code>
+WantedBy=multi-user.target
+</code>
+<note>I used user "root" to run serviio, I found that when adding disks etc. later on, or migrating disks from other distro's that serviio does not update the library, because of the file permissions. So this is what I did, there are more than one way to handle those permissions.</note>
 ==== 4b.Fedora <= 14 - Init.d script ====
 Create the initscript /etc/init.d/serviio with the following code:

Serviio Wiki

User Tools

Site Tools

Differences

Page Tools